When we bought our home, I didn't love the basement. It was a great room for kids to hang out, so it didn't need to feel like home, right? Wrong. Fast forward a year and a few baby steps and this room has become one of my favorites. I love what a little paint and a little DIY can do.
Just a few steps transformed this tile completely. Gather your supplies and make a room you love
Here is a list of products you will need to get started (I have used affiliate links for the products I used):
Roller and Foam Brush
Paint (I used leftovers. Matte paint would be best- I always love Behr from Home Depot)
Small detail brush for touch ups
STEP 1: PREP
The first step is to clean your tile really well, using a heavy duty TSP cleaner (or similar). Then using a sanding block, sand it to rough up the top, wipe it down once more with water and tape your edges.
STEP 2: PRIME
Using a good primer is super important. You will need 2-3 coats just to be sure it all stays put. I waited about an hour between coats and made sure the coverage was super even. I used this Zinsser 1-2-3 from Home Depot because I prefer working with water based. For priming, I use inexpensive brushes and plan to throw them away after use.
STEP 3: BASE COAT
I used some left over paint that I had from another project that was a satin finish, but everything I read says to use something matte. Mine worked just fine, but if you are buying all new supplies, I would chose a flat, eggshell or even chalk paint. I always swear by Behr Paint from Home Depot. Amazing coverage, I wont ever use anything else! I did 2 coats of the base color and let it dry overnight.
STEP 4: STENCIL
This is the big step and it was a little bit of a doozy. When I started, I wasn't prepared with the right supplies. First, choose a tile stencil. I chose this one from Amazon and I was very happy with it. Just be sure to order the correct size for your project. My tiles are 12 inches, so I purchased the large size.
Again, I used leftover paint from another project (semi-gloss this time), but I think matte paint would have had less bleed. I got started as soon as my stencil arrived, but I should have been prepared with the other neccesary supplies first. They made a huge difference.
The thing the made the biggest difference is spray adhesive. No matter how much tape I used, I could't get the lines as crisp as I hoped until I used adhesive. I gave it a good spray on the back every time before I set it down. Game changer.
You can buy special stencil brushes and rollers too, but I think any small roller would work. I preferred a small foam brush for the edges. The trick is to barely use any paint. You need to use a paper plate or something to off load the paint before applying in order to avoid the bleed around the edges. You can go over the stencil several times to get the coverage you want, but the less paint on the brush, the better.
When I finished everything, I went around the edges with a small paintbrush to clean up with inevitable mistakes. It wasa a little bit tedious but made the biggest difference.
STEP 5: Top Coat
I knew I needed a UV resistant, non-yellowing topcoat that would protect and seal the paint. Again, I went to my paint supplies and found what I needed. I ended up using this Rustoleum Gloss in Clear. I used 2 coats and I love the sheen it gave to the project and I think it's just the protection I was hoping for.
It was a lot of work. I like quick projects and this was more detail work than I imagined, but i am super happy with how it turned out. If you have tile that could use a face lift, I say go for it!